Filter
Top Products
24
To use the tuner of DTR-8.3, it is necessary to prepare the supplied
FM and AM antennas.
• Adjustment and placement of the FM and AM antennas for
better reception must be done while listening to a station
broadcast.
• If better reception cannot be obtained, then placement of an
outside antenna is recommended.
Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
• Refer to “Connecting the AM loop antenna” below for details on
how to connect the loop antenna.
Connecting the AM antenna cable
1. Press down the lever at the antenna terminal.
2. Insert the wire into the terminal hole.
3. Release the lever.
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend the
antenna and adjust its orientation until the clearest signal is received.
Fix it with push pins or similar items in the position that will cause
the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far away
as possible from the DTR-8.3, televisions, speaker cables, and power
cords.
If the reception is not very clear with the attached AM indoor
antenna, the use of an outdoor antenna is recommended.
Strip away the insulation from the end of
the cable, and fully insert the stripped end
of the cable.
Hint:
Either of the split ends of the AM antenna can be connected to either
terminal. Unlike speaker cabling, there is no polarity for AM
broadcast signals.
(Indoor) AM loop antenna
Connecting antennas
Insert into the hole.
FM antenna
12
3
AUDIO
P
RE OUT
L
L
AM
FM
75
R
L
CENTER
ANTENNA
Australian models
USA and
Canadian
models