Filter
Top Products
30
Turning on the power from the remote controller
Before you can use the remote controller, you must perform steps 1
and 2 above and place the DTR-8.3 in the standby state.
1. Select AV Amp in the Home menu.
2. Tap the ON button.
To return the DTR-8.3 to the standby state,
press the OFF button.
Memory preservation
The DTR-8.3 does not require memory preservation batteries. A
built-in memory backup system preserves the contents of
memory (e.g., speaker settings and surround settings) during
power failures and even when the unit is unplugged. The unit
must be plugged in order to charge the back-up system.
The length of time that the memory will be preserved will vary
depending on the ambient climate. On the average, memory
contents are protected over a period of a few weeks after the last
time the unit has been unplugged. This period may be shorter
when the unit is exposed to a highly humid climate.
To change the display of the input source from
TAPE to MD
If you connected an MD recorder to the TAPE jack on the DTR-8.3,
you can have “MD” appear when the TAPE source button is pressed.
Changing the display:
Press and hold down the TAPE source button until the display
changes from TAPE to MD (approx. 3 seconds).
To return the display to its original setting, perform the same
procedure.
• Before you plug in the DTR-8.3, confirm that all connections
have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
Turning on the power
1. Plug the power cord into an AC wall outlet.
The Standby indicator will light up.
2. Press the Standby/On button to turn on the DTR-8.3.
The display will light up and the Standby
indicator will turn off.
If you press the Standby/On button again,
the receiver returns to Standby state.
Connecting the power
Turn off
+
–
CH
VOL
MUTE
CONT
+
–
LIGHT
ON
Tape
Standby/On
OFF
Standby
To wall outlet
Standby indicator
Tape