Filter
Top Products
45
Use this sub-menu when you have a remote control sensor connected
to the IR IN terminal. The setting in this sub-menu tells the DTR-8.3
whether the remote control sensor is being used for operation of the
DTR-8.3 in the main zone or the remote zone (Zone 2).
Main: Select when you are using the remote control sensor for
operation with the remote controller in the main zone.
Zone 2: Select when you are using the remote control sensor for
operation with the remote controller in the remote zone (Zone 2).
Hardware Setup
0-2. Surr Back/Zone 2 Sub-menu
a. Surr Back/Zone 2
Zone 2: Select when connecting the speakers for the remote
zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or SURR
BACK/ZONE 2 SPEAKERS terminals (for using the internal
amplifier for Zone 2).
Surr Back: Select when not connecting the speakers for the
remote zone (Zone 2) to the SURR BACK/ZONE 2 PRE OUT or
SURR BACK/ZONE 2 SPEAKERS terminals (for using the
internal amplifier for the surround back speakers).
Note:
The SURR BACK/ZONE 2 PRE OUT and SURR BACK/ZONE
2 SPEAKER terminals
In order to have 7.1-channel playback in the main room, you must set
the Surr Back/Zone 2 setting to “Surr Back.” When set to “Surr
Back,” the surround back signals are output from the SURR BACK/
ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER
terminals. Connect the surround back speakers to the SURR BACK/
ZONE 2 SPEAKER terminals or to the speakers terminals of the
power amplifier connected to the SURR BACK/ZONE 2 PRE OUT
terminals.
When you are not using the surround back speakers in the main room
and using the internal amplifier to power the speakers for the remote
zone (Zone 2), set the Surr Back/Zone 2 setting to “Zone 2.” When
set to “Zone 2,” the Zone 2 signals are output from the SURR
BACK/ZONE 2 PRE OUT and SURR BACK/ZONE 2 SPEAKER
terminals. Connect the remote zone (Zone 2) speakers to the SURR
BACK/ZONE 2 SPEAKER terminals or to the speakers terminals of
the power amplifier connected to the SURR BACK/ZONE 2 PRE
OUT terminals.
At this time, the main room is switched to 5.1 channel playback
mode, and therefore you cannot select the THX Surround EX or
DTS-ES, which requires the sound back.
0-3. IR IN Setup Sub-menu
Advanced Menu
0.Hardware Setup
0-3.IR IN Setup
a.Position :Main
Quit:|SETUP|
Advanced Menu
0.Hardware Setup
0-2.Surr Back/Zone2
a.Surr Back/Zone2
:Surr Back
Quit:|SETUP|