Filter
Top Products
42
Listening to Radio Broadcasts
FM Mode
Tuner
Tuning /
One of the features of the DTR-6.4/5.4 that is most frequently used
is its ability to play FM and AM broadcast radio stations. The DTR-
6.4/5.4 provides a number of listening modes perfect for listening to
the radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH button on the remote
controller.
4. Press the Tuner input source button.
Each time you press the Tuner button, the
input source changes between AM and FM.
5. Using the Tuning and buttons on
the front panel, tune into the station
you desire.
• The tuner frequency changes in 100-kHz (or 50-kHz)
increments for FM and 10-kHz (or 9-kHz) increments for
AM.
• You can press the Tuning or button continuously for
more than 0.5 seconds to scan for an FM station in the
direction of the button you pressed (FM auto tuning mode).
After you release the button and a station is received in
stereo, the scanning stops.
Tuning into a radio station
“FM STEREO”
(Lights red)
Tuned in stereo Auto mode
Band Frequency
When you tune into a radio station, TUNED
indicator appears in the display. If you tune
into an FM station in stereo, then “FM
STEREO” appears. If the signal is weak, it
may be impossible to tune into the station in
stereo. In such a case, press the FM Mode
button on the front panel. The AUTO
indication disappears and the radio station is
output in the monaural mode. To return to
stereo, press the FM Mode button again.
“AUTO” appears. Some inter-station noise
may be heard, but the sound will not cut in and
out as it would if stereo was selected.
Listening to a stereo radio station (FM mode)