Filter
Top Products
24
Connecting antennas
To use the tuner of the DTR-6.4/5.4, it is necessary to prepare the
supplied FM and AM antennas.
• Adjustment and placement of the FM and AM antennas for
better reception must be done while listening to a station
broadcast.
• If better reception cannot be obtained, then placement of an
outside antenna is recommended.
Assemble the loop antenna as shown in the illustration.
• Refer to “Connecting the AM loop antenna” below for details
on how to connect the loop antenna.
1. Press down the lever at the antenna terminal.
2. Insert the wire into the terminal hole.
3. Release the lever.
Assembling the AM loop antenna
Connecting the AM antenna cable
Insert into the hole
12
3
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend
the antenna and adjust its orientation until the clearest signal is
received. Fix it with push pins or similar items in the position that
will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction
and position where you receive the clearest sound. Put it as far away
as possible from the DTR-6.4/5.4, televisions, speaker cables, and
power cords.
If the reception is not very clear with the attached AM indoor
antenna, the use of an outdoor antenna is recommended.
Hint:
Either of the split ends of the AM antenna can be connected to
either terminal. Unlike speaker cabling, there is no polarity for AM
broadcast signals.
Connecting the included antennas
ANTENNA
FM
75
AM
IR OUT
56K
A
40K
B
ZONE 2
OUT
DC IN
24V 1A
L
ZONE 2
LINE OUT
12 V
T
RIGGER
OUT
A
FM antenna
Australian models
USA and
Canadian
models
(Indoor)
AM loop antenna