Filter
Top Products
Autoloader Operation
94 SSL1016 Tape Autoloader Reference Guide
View Tape Drive Version
To view the tape drive version:
1. On the main menu, scroll to Status. (See Figure 61.)
2. Press Enter.
3. On the Status submenu, scroll to Drive Info. (See Figure 62.)
4. Press Enter.
5. On the Drive Info submenu, scroll to Version. (See Figure 63.)
6. Press Enter.
A list of messages similar to the following screen appears.
Figure 70: Tape drive version screen
Table 10: Tape Drive Status Messages
SCSI ID The number indicates the autoloader SCSI ID number.
Loader LUN The number indicates the Logical Unit Number of the
autoloader.
Compression Indicates whether the tape drive compression is enabled or
disabled.
Drive Cart Indicates whether a cartridge is present in the drive.
Table 11: Tape Drive Version Messages
Product Type The number indicates the type of product installed (DLT1).
Policy Version The number indicates the version of the policy processor for
the tape drive, typically the tape drive firmware version.
Servo Version The number indicates the servo processor firmware version.
Product Type: DLT 1
Policy Version:
35.52
Servo Version:
65.6