Filter
Top Products
Installation and Configuration
38 SSL1016 Tape Autoloader Reference Guide
Daisy Chaining
The autoloader does not support daisy chaining with other products. You can
daisy chain one additional autoloader using the 68-pin VHDCI connector to
68-pin VHDCI connector 3 foot (.092 meter) cable. You must then install a
terminator on the second autoloader.
Ethernet Connection
Attach one end of the RJ-45 cable to the autoloader. Attach the other end to a
10/100 hub or switch.
Note: This step is not required for operation, but is necessary if you want to use the
autoloader Web administration feature.
Power On
Carefully inspect your power cord and make sure that it is the correct one for your
country or region. If the power cord is not correct, contact your customer service
representative.
To connect the power cord:
1. Make sure that the power switch on the back of the autoloader is off (the 0 is
pressed).
2. Connect the female end of the power cord to the power connector on the back
of the autoloader.
3. Plug the male end of the power cord into the power source.