Filter
Top Products
Autoloader Operation
103SSL1016 Tape Autoloader Reference Guide
Run Inventory
The autoloader automatically runs an inventory when you power it back on or
insert a magazine. If you need to run an inventory in addition to this, you can use
Web Administration to do it remotely.
To run an inventory:
1. On any Web Administration page, click Commands.
2. On the Commands page, click Inventory.
Set to Home
If the autoloader is not able to successfully execute a move or inventory
command, try executing a HOME command and then retry the move or inventory
command again.
The HOME command resets the autoloader as a means to help the autoloader
recover from an unknown internal condition. You should very rarely need to use
this command.
To set to Home:
1. On any Web Administration page, click Commands.
2. On the Commands page, click Home.