Filter
Top Products
Installation and Configuration
35SSL1016 Tape Autoloader Reference Guide
2. Install the front standalone bracket cover:
a. Place the cover over the autoloader bracket.
b. Place the washers over the bracket holes and secure with a screw.
c. Repeat for the other side.
Figure 15: Installing the front standalone bracket covers
Clearance
Place the autoloader on a desk, table, or other stable, horizontal surface. Make
sure the fan at the rear of the autoloader is not obstructed. Allow about 6 inches
(about 15 cm) from wall or solid object at the rear. Allow about 12 inches (about
30 cm) to insert a cartridge in the mailslot, and about 28 inches (about 71 cm) to
insert or remove a magazine at the front.