Filter
Top Products
Installation and Configuration
34 SSL1016 Tape Autoloader Reference Guide
Removing the Autoloader From the Rack
When removing the autoloader from the rack:
■ Always use at least two people.
■ Install the optional installation brackets if there is no device installed below
the autoloader.
■ Before powering off the autoloader, remove the magazines.
Standalone Installation
Use these instructions if you will not be installing your autoloader into a rack.
Preparation
To prepare your autoloader for standalone installation:
1. Place one rear standalone leg into place and secure with two screws. Repeat
for the other side.
Figure 14: Installing the rear standalone leg