Filter
Top Products
Installation and Configuration
32 SSL1016 Tape Autoloader Reference Guide
9. Slide the autoloader in place 1 so that:
a. The mounting studs on the front ears of the autoloader slide into the holes
between the clip nuts.
b. The front ears of the autoloader align with the front clips.
c. The rear support brackets engage the locking tab on the rear U-channel
brackets.
Figure 12: Attaching the autoloader to the front of the rack
10. Loosely install a screw in each front clip nut to attach the ears 2.
11. Verify that the autoloader is level. Adjust as needed.
12. Tighten the four screws that attach the ears to the front clip nuts.
13. Tighten the four screws that connect the U-channel brackets to the rear clip
nuts.
14. Install and tighten the four screws that connect the support brackets to the
U-channel brackets.
1
2
2