Filter
Top Products
Installation and Configuration
45SSL1016 Tape Autoloader Reference Guide
To set the control mode:
1. On the main menu, scroll to Configuration.
Figure 22: Main menu
2. Press Enter.
3. On the Configuration submenu, scroll to Change Mode.
Figure 23: Select Change Mode
4. Press Enter.
The mode options appear. A checkmark appears after the enabled mode.
Figure 24: Mode Options
5. Do one of the following:
■ To change the control mode, scroll to the desired mode and press Enter.
A checkmark appears. Press Enter again.
■ To leave the control mode unchanged, press Escape.
6. Reboot for the new mode to take affect.
a. Press and hold the power button on the front panel until Power Off
appears on the LCD.
b. Press the power button again to power on the autoloader.
The new control mode is now in effect.
Status
Commands
Configuration
Diagnostics
SCSI ID
Ethernet
Time
Change Mode
Cleanin
g
Ta
p
e
3 Random
Mixed
Sequential
Seq Cycle Mode