Filter
Top Products
Installation and Configuration
39SSL1016 Tape Autoloader Reference Guide
Figure 17: Connecting the power cord
Note: Do not power on the host before powering on the autoloader.
To power on the autoloader:
1. Push the power switch that is on the back of the autoloader to the on position
(the | is pressed).
Wait while the autoloader performs its power-on sequence. During this time,
the following activities occur:
■ The cooling fans begin to operate.
■ The LCD illuminates and displays power-on messages.
■ The autoloader performs a power-on self-test (POST).
■ The autoloader performs a calibration and magazine element status.
Note: Depending on how the autoloader was last powered off, you may need to press
the On/Off button on the front of the autoloader.