[2] Remote control unit operations during multi-source playback (selecting the input source)
This operation is not possible in the REC OUT mode.
This operation is possible when ZONE2 mode is selected.
1
Select “ZONE2” using the
ZONE2 button.
(Remote control unit)
2
Press the ZONE2 “ON”
button.
To turn off the ZONE2
mode.
Press the ZONE2 “OFF”
button.
(Remote control unit)
3
Press the input source button
• The ZONE2 source switches directly.
4
The output level of the ZONE2 OUT terminals
can be controlled using the VOLUME + and –
buttons on the remote control unit.
The output level of ZONE2 OUT can be
controlled only if ZONE2 vol. level is set
“Variable” at Zone2 Control in System Setup
Menu. (see page 26)
DEFAULT SETTING
(ZONE2 VOLUME LEVEL) :
- - - dB (MINIMUM)
(Remote control unit)
5
When the ZONE2 SOURCE
function is set to TUNER, the
preset channel can be
selected using the CHANNEL
+ and – buttons on the
remote control unit.
(Remote control unit)
11
SURROUND
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the
different speakers. This adjustment can be performed with the system setup (see page 20) or from the remote
control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only
effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes
are automatically stored in the memory.
Before playing with the surround function
1
Press the TEST TONE button.
(Remote control unit)
2
Test tones are output from
the different speakers. Use
the channel volume adjust
buttons to adjust so that the
volume of the test tones is
the same for all the speakers.
(Remote control unit)
3
After completing the
adjustment, press the TEST
TONE button again.
