Filter
Top Products
23
ENGLISH
3
Select the component (Y, PB
/CB and PR/CR) video input terminal to be assigned to the input source.
q Select the source selection. w Select the component video input terminal.
Select “NONE” for sources for which the
component (Y, P
B/CB and PR/CR) video
input is not to be used.
When the default, “Yes”, is selected,
the settings are reset to the factory
defaults.
4
Enter the setting.
The Input Setup Menu reappears.
3-4 Setting the Video Input Mode
1
Select “Video Input Mode” at the Input Setup Menu.
Video In Mode
*Input Setup
2
Display the Video Input Mode screen.
DVD : Auto
*Video In Mode
3
q Select the input source for
which you want to set the Video
Input Mode.
w Select the mode as below.
AUTO
COMPONENT
Svideo Video
The details in each mode are as follows.
AUTO: When there are multiple input signals, the input signals are detected and the input signal
to be output from the video monitor output terminal is selected automatically in the
following order: component video, S-Video, composite video.
Component: The signal connected to the component video terminal is always played.
Video conversion is not conducted, so no image is output from the monitor output terminal
when there is no input signal to the component terminal.
S-Video: The signal connected to the S-Video terminal is always played.
The S-Video input signal is converted and output from the composite and component
monitor output terminal.
Video: The signal connected to the composite video terminal is always played.
The composite video input signal is up-converted and output from the S-Video and
component monitor output terminals.
NOTE:
Down-converting from the component video signal to the S-Video and composite video signal is not
possible, so when not using the component video monitor output terminal connect the player using the
S-Video or composite video input terminal.
Cautions on the video conversion function:
When the component video terminals are used to connect the AVR-2805 with a TV (or monitor, projector,
etc.) and the video (yellow) or S video terminals are used to connect the AVR-2805 with a VTR, depending
on the combination of the TV and VTR the picture may flicker in the horizontal direction, be distorted, be
out of sync or not display at all when playing video tapes.
If this happens, connect a commercially available video stabilizer, etc., with a TBC (time base corrector)
function between the AVR-2805 and the VTR, or if your VTR has a TBC function, turn it on.
4
Enter the setting.
The Input Setup Menu reappears.
3-3 Setting the Component In Assign
• This setting assigns the color difference (component) video input jacks of the AVR-2805 for the different input
sources.
1
Select “Component In Assign” at the Input Setup
Menu.
Component In
*Input Setup
2
Display the Component In Assign screen.
DVD : V1
*Component In
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit) (Remote control unit)
(Remote control unit)