Filter
Top Products
22
ENGLISH
1
2
At the System Setup Menu select “Input Setup”.
Display the Input Setup Menu screen.
Input Setup
*System Setup
Setting the Input Setup
3
(Remote control unit)
(Remote control unit)
3-1 Setting the Digital In Assignment
• This setting assigns the digital input jacks of the AVR-2805 for the different input sources.
1
At the Input Setup Menu select “Digital In Assign”.
Digital In
*Input Setup
2
Display the Digital Inputs screen.
CD : COAX1
*Digital In
3
Select the digital input jack to be assigned to
the input source.
w Select the digital input
jack
4
Enter the setting.
The Input Setup Menu
reappears.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
Select “OFF” for input sources for which no
digital input jacks are used.
If “Ye s” is selected for “Default”, the
settings are automatically reset to the
default values.
3-2 Setting the Ext. In Subwoofer Level
• Set the method of playback of the analog input signal connected to the Ext. In Subwoofer.
1
Select “Ext. In Subwoofer Level” at the Input Setup
Menu.
Ext.In SW Lev.
*Input Setup
2
Display to the Ext. In Subwoofer Level screen.
SW Lev.: +15dB
*Ext.In SW Lev.
3
Select the desired setting.
Select according to the specifications of the player being used. Also refer to the
player’s operating instructions.
+15 dB (default) recommended. (0, +5, +10 or +15 can be selected.)
4
Enter the setting.
The Input Setup Menu reappears.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
NOTES:
• The OPTICAL 3, 4 jacks on the AVR-2805’s rear
panel are equipped with an optical digital output
jack for recording digital signals on a CD recorder,
MD recorder or other digital recorder. Use this for
digital recording between a digital audio source
(stereo - 2 channel) and a digital audio recorder.
• Do not connect the output of the component
connected to the OPTICAL 3, 4 OUT jack on the
AVR-2805’s rear panel to any jack other than the
OPTICAL 3, 4 IN jack.
•“PHONO” and “TUNER” cannot be selected on
the Digital In Assignment.
q Select the input source