Filter
Top Products
26
ENGLISH
5-2 Setting the Zone2 Vol. Level
Set the Zone2 pre-out output level adjustment.
1
At the Option Setup Menu select “Zone2 Vol. Level”.
Zone2 Vol. Lev.
*Option Setup
2
Display the Zone2 Vol. Level screen.
3
Select the desired setting.
Variable:
The level can be adjusted freely using the buttons on the
remote control unit.
0 dB, –40 dB:
The output level is fixed at the set level and the volume
can no longer be adjusted.
NOTE:
• When “ZONE2” is selected at System Setup Menu
“5-1. Power Amp Assign”, the Zone2 vol. Level is all
set to “Variable” including preout level and this menu
is not displayed.
Variable
*Zone2 Vol.Lev.
4
Enter the setting.
The Option Setup Menu reappears.
5-3, 5-4 Setting the Trigger Out Setup
• There are two 12V DC Trigger Out outputs on the rear panel that can be used to control other devices with
compatible trigger inputs.
• Set the Trigger Out output 1 for the different input sources.
1
Select “Trigger Out 1 Setup” at the Option Setup Menu.
Trigger Out 1
*Option Setup
2
Display to the Trigger Out 1 Setup screen.
3
Select the Zone (MAIN or Zone2).
ZONE : MAIN
*Trigger Out 1
4
q Select the input source. w Select “ON” or “OFF”.
5
Enter the setting
The Option Setup Menu reappears.
Set the Trigger out 2 Setup in the same way.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)