Filter
Top Products
Use this to mute the audio
output temporarily.
Press the MUTING button.
The Muting level is the same level as set
with “5-5 Setting the Muting Level”.
Cancelling MUTING mode.
Press the MUTING button again.
36
ENGLISH
Playing audio sources (CDs and DVDs)
1
PURE DIRECT mode
In this mode, the music is played with an
extremely high level of sound quality.
When this mode is set, all the video-related
circuits are turned off so that music signals can
be reproduced with high quality. When an
analog mode is selected, the digital processing
circuitry is also turned off to achieve analog
sound with even higher purity. (See NOTES)
1
3
2
1
The AVR-2805 is equipped with three 2-channel playback modes exclusively for music.
Select the mode to suit your tastes.
(Main unit)
2
DIRECT mode
Use this mode to achieve good quality 2-
channel sound while watching images. In this
mode, the audio signals bypass such circuits as
the tone circuit and are transmitted directly,
resulting in good quality sound.
(Remote control unit)
3
STEREO mode
Use this mode to adjust the tone and achieve
the desired sound while watching images.
(Remote control unit)
NOTES:
• The system setup function cannot be used when the PURE DIRECT mode is set. To use the system setup
function, cancel the PURE DIRECT mode.
• The ZONE2 video output is not output in the PURE DIRECT mode.
• The channel level and surround parameters in the PURE DIRECT mode are the same as in the DIRECT mode.
• When the PURE DIRECT button is pressed while in the PURE DIRECT mode, the PURE DIRECT mode is
cancelled.
• The subwoofer’s channel level must be set to “OFF” in order to turn off the digital circuit in the PURE DIRECT
mode.
2 3 1
BASS TREBLE
[1] Adjusting the sound quality (TONE)
The tone control function will not work in the PURE
DIRECT and the DIRECT mode.
After starting playback
1
The tone switches as follows each time the
TONE CONTROL button is pressed.
(Main unit)
2
With the name of the volume
to be adjusted selected, turn
the SELECT knob to adjust
the level.
SELECT
(Main unit)
• To increase the bass or treble:
Turn the control clockwise.
(The bass or treble sound can be increased to
up to +6 dB in steps of 1 dB.)
• To decrease the bass or treble:
Turn the control counterclockwise.
(The bass or treble sound can be decreased to
up to –6 dB in steps of 1 dB.)
3
If you do not want the bass and treble to be
adjusted, turn on the tone defeat mode.
(Main unit)
The signals do not pass
through the bass and treble
adjustment circuits, providing
higher quality sound.
1
[2] Listening over headphone
1
1
Plug the headphone’ plug
into the jack.
Connect the headphone
to the PHONES jack.
The pre-out output
(including the speaker
output) is automatically
turned off when
headphone are
connected.
1
PHONES
NOTE:
To prevent hearing loss, do not raise the volume level
excessively when using headphone.
[3] Turning the sound off temporarily (MUTING)
1
(Remote control unit)
(Remote control unit)