Filter
Top Products
15
ENGLISH
1
Select the items.
The measurement results of each item can be checked
here.
Sp Config.Check
*Auto Setup
Check of the measurement results
2
Press the ENTER button and display the verification
screen.
[Speaker Config. Check] [Delay Time Check] [Channel Level Check]
3
If the check ends, press the ENTER button again.
4
Select from the following three items based on the
measurement results.
• Store : Set with the checked measurement value.
• Retry : Perform the measurement again.
• Cancel : Cancel the checked measurement value.
Store
*Auto Setup
5
When the “Store” is selected, all parameters are stored
up.
When the “Retry” is selected, it measures again.
NOTE:
• When measurements have been made using the measurement microphone,
speakers with a built-in filter such as subwoofers might be set with a value that
differs from the physical distance because of the internal electrical delay.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
1-2 Setting the Manual EQ Setup
Adjust the tone of the various speakers except subwoofer while listening to the sound (music).
1
Select “Manual EQ Setup” at the Auto Setup / Room
EQ Menu.
Manual EQ Setup
*AutoSet/RoomEQ
2
Display the Manual EQ Setup screen.
Channel : FL
*ManualEQ Setup
3
Select the speaker to be set.
The display changes as follows.
SB
FL
FR C
SL
SR
SBL
SBR
1spkr
Flashing
When the surround back speaker setting is set to
“1spkr” at “Speaker Configuration”, this is set to
“SB”.
Channel : FL
*ManualEQ Setup
4
Select the frequency.
63Hz : 0.0dB
*ManualEQ Setup
5
Use the cursor left and right buttons to adjust the Gain
level.
• Each frequency can be adjusted the range from –6 dB
to +6 dB in 0.5 dB step.
6
Enter the setting.
The Auto Setup / Room EQ Menu reappears.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)