Filter
Top Products
14
ENGLISH
4
q Select the “Start”.
Start
*Auto Setup
(Remote control unit)
w Press the CURSOR left button.
5
Start the measurements.
Measurement of each channel is performed as follows.
Display
FL
FR CSW
2
3
SBL
SBR
1
SL
SR
1 Only the front speakers (A) is measured. Even if the
front speakers (B) is set, the setting automatically
switches to the front speakers (A) once
measurements are completed.
2 Subwoofer speaker is measured twice.
3 When “ZONE2” is selected, this is not displayed.
After each channel is measured, “Calculating”
appears.
The display switches to Auto Setup check screen
automatically.
NOTES:
• Measurement is canceled when
MASTER VOLUME is operated while
the Auto Setup is performed.
• Set the volume to halfway and set the
crossover frequency to the maximum
or low pass filter off if your subwoofer
can adjust the output volume and the
crossover frequency.
About automatic retry
Remeasurement starts automatically to receive proper result of measurement.
Remeasurement is performed to 2 times, and “Retry1” or “Retry2” is displayed
on screen during remeasurement.
(Remote control unit)
About the error message
These error screens will be displayed when performing the measurements of Auto Setup / Room EQ and the
automatic measurements can not be completed because of the speaker arrangement, measurement
environment, or other factors. Please check the following matters, reset the pertinent items, and measure again.
When there is too much noise in the room, the speakers may not be detected properly. Should this happen,
perform the measurements when the noise level is low, or switch off the power of the equipment that is
producing the noise for the duration of the measurements.
q This screen will be displayed when the speakers
required for producing suitable reproduction have
not been detected.
• The front L and front R speakers were not
properly detected.
• Only one channel of the surround speakers was
detected.
• Sound was output from the R channel when
only one surround back speaker was connected.
• The surround back was detected, but the
surround speaker was not detected.
Check that the pertinent speakers are properly
connected.
(see page 9)
w This screen will be displayed when the speaker
polarity is connected in reverse.
Check the polarity of the pertinent speakers.
For some speakers, the screen below may be
displayed even though the speakers are
properly connected. If so, select “Skip
0
”.
e This screen will be displayed when accurate
measurements cannot be made due to the input
level to the microphone being too high.
Set up the speakers so that their position is
farther away from the listening position.
Lower the volume of the subwoofer.
r This screen will be displayed when the
measurement microphone is not connected, or
when all of the speakers have not been detected.
Connect the measurement microphone to the
microphone connector.
Check the speaker connections.