Filter
Top Products
44
<PRE1282>
En
1
Loading/unloading a disc
1 Press the POWER switch to turn the power ON.
÷ The function indicator blinks green.
÷ The display panel is illuminated.
2 Press the OPEN/CLOSE 0 button to open the
disc tray.
“OPEN” is displayed and the tray comes out.
÷ After recording or skip information recording, it takes a few
seconds before the disc tray can open because the recording
information is being written on the disc. “OPEN” blinks
during this period.
3 Place a disc in the disc tray
÷ Place the disc in the center of the tray with the label side up.
÷ When using an 8 cm (3 inch) disc make sure the disk is
located in the groove in the middle of the CD tray.
÷ Ensure only one disc is loaded at a time
÷ The disc must be loaded label side up. ( Please note this
differs from the CDR-800 where the disc is loaded with the
label side down.)
4 Press the OPEN/CLOSE 0 button to close the
disc tray.
“CLOSE” is displayed and the tray is closed.
The disc tray can also be closed by
÷ pressing the 3 button.
÷ pushing the disc tray lightly.
÷ When a disc is loaded, the disc type is identified and the
information on the disc is read. (During this time,
“CD?”,
“CD-R?” and “CD-RW?” are displayed alternately.)
A Display for a non-recorded CD-R disc:
B Display for a non-recorded CD-RW disc:
C Display for a partially recorded CD-R disc:
D Display for a partially recorded CD-RW disc:
E Display for a prerecorded CD or finalized CD-R disc:
The total playing time is displayed.
F Display for a prerecorded and finalized CD-RW disc:
The total playing time is displayed.
G An attempt is made to start playback without loading a
disc:
DISC LOADING/UNLOADING
4
1 Function indicator
1 Indicateur de fonction
1 Indicador de función
Label surface
Emplacement
d’étiquette
Superficie de la
etiqueta
3
2
POWER
OFF
ON
OPEN/
CLOSE
OPEN/
CLOSE
1
3
1
2, 4