Filter
Top Products
8
VIDEO OUT
5 Connect the video input jack of your
TV to the VIDEO OUT jack with the
supplied video cable.
When using a TV
Turn on the TV and select the video input so you can
view the pictures from this system.
Tip
For even higher quality video images, you can use an
optional S-video cable to connect the S VIDEO input
jack on your TV to the S VIDEO OUT jack.
6 For models with a voltage selector, set
VOLTAGE SELECTOR to the position
of your local power line voltage.
VOLTAGE SELECTOR
220V
120V
230
240V
-
S VIDEO
OUT
7 Connect the power cord to a wall outlet.
If the supplied adapter on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adapter).
8 (Asian model only)
Set the color system according to your
TV. The factory setting is NTSC. Each
time you perform the procedure below,
the color system changes as follows:
NTSC y PAL
1 Press ?/1 to turn the system on.
2 Press FUNCTION repeatedly until “DVD”
appears in the display.
3 Press x.
4 Press ?/1 while holding down NEXT.
The system turns off.
5 Press ?/1 to turn on the system.
The system turns on and the color system
is changed.
9 Remove the dummy disc.
A dummy disc is placed in the DISC 1
tray at shipment to prevent damage to
the system during transportation.
Before using the system for the first
time, remove the dummy disc following
the steps below.
1 Press ?/1 to turn on the system.
2 Press A 1 and remove the dummy disc
from the disc tray.
3 Press A 1 to close the disc tray.
Notes on the dummy disc
• You must use the dummy disc for protection
when transporting the system. Be sure to keep
the dummy disc in a secure place (page 90).
• There are no signals recorded on the dummy
disc.
Step 1: Hooking up the system
(continued)
To the S VIDEO input of the TV