Filter
Top Products
53
C4630 SE HOME AUDIO SYSTEM
AUDIO (continued)
Problem Solution
No audio in zone a) Are speakers connected?
b) Is zone ON?
c) Is zone volume turned up?
d) Check zone’s M
AXIMUM VOLUME/DEFAULT
VOLUME settings in Sonance Control
Manager software.
No Paging signal in zones. a) Be sure device’s 12V Page trigger input is connected to C4630 SE’s CONTROL
INPUT (see page 16).
b) Be sure Page trigger device is outputting 6 – 24V AC/DC.
c) In an expanded system (multiple C4630 SEs) be sure the Paging audio source
is connected to the P
AGE IN jack on the primary C4630SE (see page 17).
d) In an expanded system, be sure P
AGE IN/OUT jacks are connected between
C4630 SEs in an expanded system (see page 17).
No audio in zones driven by secondary a) Be sure the Source Outputs on the primary C4630 SE (the one connected to
C4630 SEs in an expanded system the source components) are connected to the Source Inputs on the secondary
C4630 SE(s). See page 13.
b) Check the Sonance Control Manager Volume Offset settings for sources on
secondary C4630 SEs (should be ‘0’.) See page 30.
EXTERNAL AMPLIFIERS
Problem Solution
Keypad or remote VOLUME UP/DOWN a) Make sure the specific Zone FIXED/VARIABLE output switch is in the FIXED (IN)
commands change volume in all sub- position (see page 13).
zones when using external multi- b) Make sure the Zone’s D
EFAULT and MAXIMUM VOLUMES are set at their appropriate
channel amplifier for sub-zone maximum volume in Sonance Control Manager software to achieve proper
expansion audio level in sub-zones. See page 29.
Keypad or remote V
OLUME UP/DOWN Make sure the specific Zone FIXED/VARIABLE output switch is in the VARIABLE (OUT)
do not adjust volume when using an position (see page 13).
external amplifier.