Filter
Top Products
25
C4630 SE HOME AUDIO SYSTEM
Transferring System Information to the C4630 SE
All programming that you perform in the Sonance Control Manager must be transferred from your
computer to the C4630 SE unit via its front-panel USB connection (see
Figure 27
). The C4630 SE comes
with a USB cable that connects between the USB connector and your computer.
Note: Before you can transfer programming to the C4630 SE via the USB port, you must
initialize the C4630 SE to your computer. To do this, provide power to the C4630 SE then connect
the USB cable between it and your computer. Your computer should recognize the C4630 SE and
automatically install the required drivers to the appropriate folders.
If your computer does not recognize the C4630 SE, you can go to the computer’s Device Manager
(under C
ONTROL PANEL>SYSTEM>HARDWARE>DEVICE MANAGER) and induce the computer to scan for new hardware attached by
selecting S
CAN under the ACTION option at the top of the window.
To transfer programming to the C4630 SE:
1. Program the Sonance Control Manager software as described in the sections below.
2. When the programming is completed, connect the included cable between the C4630
SE’s USB connection and your computer.
3. Open the C
OMMUNICATION menu and select SEND TO DEVICE. The DEVICES IN THE CURRENT SYSTEM
screen (
Figure 28
) will appear. All C4630 SEs in the system will be listed in the window.
4. Click on the S
END button for the C4630 SE to which you want to transfer the programming.
Once the data transfer is complete, close the D
EVICES in the CURRENT SYSTEM window and
disconnect the USB cable from the C4630 SE. The C4630 SE will then resume operation
according to the new programming.
Updating the Sonance Control Manager Software and Firmware
Sonance may from time to time may make upgrades to the Sonance Control Manager software and the C4630 SE firmware
available via the Sonance website (www.sonance.com). To check for the latest versions go to www.sonance.com and select
the E
LECTRONICS category. From there, select the C4630 SE and go to the DOWNLOADS section. Note the version numbers of
S
ONANCE CONTROL MANAGER and C4630 SE firmware that are listed.
Upgrading Sonance Control Manager Software
To check which version of Sonance Control Manager is loaded on your computer,
launch the Sonance Control Manager program, select the H
ELP menu, then scroll
down to A
BOUT. The box shown in
Figure 29
will appear. If the software version
on the computer is earlier than the one listed on the Sonance website:
1. Follow the instructions on the website to download the newer version of
Sonance Control Manager onto your computer.
2. Unzip the S
ETUP.EXE file and double-click it. Follow the instructions to install
the program.
USB
Figure 27:
USB Connection
Figure 28: DEVICES IN THE
CURRENT SYSTEM Screen
Figure 29:
Sonance Control Manager Version
Software Version