Filter
Top Products
16
C4630 SE HOME AUDIO SYSTEM
Control Output, Control Input and Sync Connections (see Figure 11)
Control Out Terminal
One 2-wire screw connector that outputs 12VDC @ 100mA when at least one C4630 SE zone is
active. Turns OFF (0VDC) when all zones are OFF. Can be used for triggering external devices
such as a zone-specific external amplifier. Accepts one pair 14 – 24 AWG wire.
CONTROL I
NPUT Terminal
General trigger input that can be used for Paging or sense input as part of a C4630 SE
S
TATUS test in a macro. Requires 5 – 24V AC or DC @ 100mA. Accepts one pair 12 –24AWG
wire.
Wiring the CONTROL Connections
1. Strip approximately ¼" of insulation from each conductor and twist the strands until tight to prevent stray strands.
2. Be sure to maintain proper polarity by connecting the appropriate ‘+V’ and ‘GND’ terminals on the device to the
appropriate ‘+V’ and ‘GND’ terminals on the C4630 SE. Be sure connections are tight and that there are no frayed ends
sticking out that could cause a short-circuit.
SYNC Connections
Two 3.5mm mini jacks used to trigger-link up to four C4630 SEs for Party Mode control (see sidebar) and
provide communication between multiple C4630 SE units that form large systems with more than 6 zones. Use mono
3.5mm mini cables to daisy-chain the Sync jacks of all C4630 SE units in the system.
Audio and IR will pass-through multiple C4630 SEs that are in the Standby mode. Power for the source components should
be managed separately or left ON.
If no other zones are ON and a zone on a C4630 SE is turned ON with a Source button Press, only that C4630 SE and
that zone will turn ON.
+ OUT - INPUT
12 VDC @
100 mA
+6 -24
AC/DC
CONTROL
SYNC
Figure 11:
Control Input/ Output
and Sync Connections
PARTY MODE
In
a
system
comprising
multiple
C4630
SEs
with
S
YNC
connections,
if
any
system
zone
configured
for
Party
Mode
is
turned
ON
with
a
P
RESS
-AA
ND
-
H
OLD
,
a
sync
code
will
be
sent
to
the
other
C4630
SEs
to
turn
ON
all
zones
configured
for
Party
Mode.
Source
and
Paging
audio
signals
will
be
shared
between
the
C4630
SEs
as
well
as
source
component
IR
control
codes.
When
Party
Mode
is
activated
all
zone
and
system
functions
with
the
exception
of
Programmed
IR
will
function
the
same
as
on
a
system
with
a
single
C4630
SE.
See
page
29
for
more
information
about
Party
Mode.