Filter
Top Products
Controlling the rest of your system
10
89
en
Chapter 10:
Controlling the rest of your system
Operating multiple receivers
The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
•Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 114).
1 Check the operation selector switch to
MAIN
.
2Press .
3 Press and hold
REMOTE SETUP
, then release it after
the LED flashes twice.
4 Use the number buttons to enter the 5-digit preset
code (see below).
• Receiver 1: 6 1 9 3 5 (Default)
• Receiver 2: 6 2 6 3 0
• Receiver 3: 6 2 6 3 1
• Receiver 4: 6 2 6 3 2
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
To operate another receiver, start over from step 1 to
input its preset code.
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as DVD or CD) using the
component’s manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see Programming signals from other remote
controls on page 90).
Note
•You can cancel or exit any of the steps by pressing
. To go
back
a step, press RETURN.
•After ten seconds of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1 Press the input function button for the component
you want to control.
1
When assigning preset codes to TV CONTROL, press TV
CTRL here.
2 Press and hold
REMOTE SETUP
, then release it after
the LED flashes twice.
3 Use the number buttons to enter the 5-digit preset
code.
See Preset code list on the separate booklet.
The LED flashes twice when the preset code has been
properly registered. When the preset code is fully input,
the LED flashes once to indicate that the setting has
failed.
4 Repeat steps 1 through 3 for the other components
you want to control.
To try out the remote control, switch the component on or
off (into standby) by pressing SOURCE. If it doesn’t
seem to work, select the next code from the list (if there
is one).
INPUT
123
HDMI OUT
SLEEPMCACC
INPUT
SELECT
SIGNAL SEL
456
DIMMERA.ATTSBch
789
CLASS
MASTER
VOLUME
CH LEVELD.ACCESS
/CLR
0
ENTER
13
456
789
0
2
REMOTE
SETUP
ZONE 2
MAIN
ZONE 3
AUDIO
MULTI OPE
INFO
DISP
CH
RECEIVER
TV CTRL
RECEIVER
REMOTE
SETUP
MAIN
RECEIVER
Note
1 You can’t assign , TUNER, HOME MEDIA GALLERY, iPod USB, XM or SIRIUS.
RECEIVER
RECEIVER
SC-9540.book 89 ページ ２００９年４月２４日 金曜日 午後１時４２分