Filter
Top Products
Using other functions
09
88
en
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1 Switch the receiver into standby.
2 While holding down
ENTER
on the front panel,
press
STANDBY/ON
.
The display shows RESET NO .
3 Select ‘
RESET
’ using
/
, then press
ENTER
on
the front panel.
The display shows RESET? OK.
4 Press
ENTER
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
Digital Video Conversion ON
SPEAKERS A
Surround Back System Normal
Speaker System Front SMALL
Center SMALL
Surr SMALL
SB SMALLx2
SW YES
Crossover 80 Hz
X-Curve OFF
THX Audio Setting 4 ft<
DIMMER Brightest
Inputs
See Input function default and possible settings on page 45.
MULTI-ZONE
ZONE 2/3 Volume Level Variable
ZONE 2/3 Volume –60 dB
HDMI
HDMI Audio Amp
HDMI output HDMI OUT ALL
KURO LINK ON
DSP
Surround back channel Processing ON
Phase Control ON
Full Band Phase Control OFF
Sound Retriever
iPod/USB or HOME
MEDIA GALLERY
function
ON
Other functions
OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Up Mix ON
Digital Safety OFF
Effect Level EXT.STEREO 90
Other modes 50
2 PL II Music
Options
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode (HP) STEREO
See also Setting the Audio options on page 82 for other default
DSP settings.
MCACC
MCACC Position Memory M1: MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10.00 ft
Standing Wave
(M1 to M6)
Standing Wave
On/Off
ON
ATT of all channels/
filters
0.0 dB
SWch Trim 0.0 dB
EQ Data (M1 to M6) All channels/bands 0.0 dB
EQ Trim 0.0 dB
Setting Default
SC-9540.book 88 ページ ２００９年４月２４日 金曜日 午後１時４２分