Filter
Top Products
Connecting your equipment
03
18
en
9 Control input/output
Use to connect other Pioneer components so that you
can control all your equipment from a single IR remote
sensor.
See Operating other Pioneer components with this
unit’s sensor on page 37.
10 RS-232C connector
Use for connection to a PC for graphical output when
using Advanced MCACC or Full Band Phase Control.
See Connecting a PC for Advanced MCACC output on
page 38.
11 Component video inputs (x3)
Use the inputs to connect any video source that has
component video output, such as a DVD player.
See Connecting your DVD player with no HDMI output
on page 27.
12 MULTI-ZONE audio/video outputs
Use to connect a second or third amplifier and monitors
or TVs in a separate room.
See MULTI-ZONE setup on page 35.
13 Composite, S-Video and Component video monitor
outputs
Use to connect monitors and TVs.
See
Connecting your TV with no HDMI input on
page 28.
14 Stereo analog audio source inputs (x3)/output (x1)
Use for connection to audio sources such as CD players,
tape decks, turntables, etc.
See Connecting other audio components on page 32.
15 Audio/video source inputs (x5)/output (x1)
Use for connection to audio/visual sources, such as DVD
players/recorders, VCRs, etc. Each set of inputs has jacks
for composite video, S-Video and stereo analog audio.
See Connecting an HDD/DVD recorder, VCR and other
video sources on page 30.
16 AM and FM antenna terminals
Use to connect indoor or outdoor antennas for radio
broadcasts.
See Connecting AM/FM antennas on page 33.
17 Multichannel pre-amplifier outputs
Use to connect separate amplifiers for front, center,
surround, surround back and subwoofer channels.
See Connecting additional amplifiers on page 33 (see
also Installing your speaker system on page 22 for
powered subwoofer connection).
18 Multichannel analog audio inputs
7.1 channel inputs for connection to a DVD player with
multichannel analog outputs.
See Connecting the multichannel analog inputs on
page 31.
19 Speaker terminals
Use for connection to the main front, center, surround
and surround back speakers.
See Connecting the speakers on page 21.
20 AC power inlet
Connect the supplied power cord here.
See Plugging in the receiver on page 41.
SC-9540.book 18 ページ ２００９年４月２４日 金曜日 午後１時４２分