Filter
Top Products
78
Section 4 Configure
Leave the
Enable NAT over Tunnel
choice as
Off
unless your network
administrator instructs otherwise.
Task 4: Make the IPSec Tunnel Entries
Enter the initial group of tunnel parameters. Refer to your Setup Work-
sheet and the Glossary of VPN Terms as required. Perform the following
steps:
Step 1 Enter tunnel
Name
.
Step 2 Enter the
Peer External IP Address
.
Step 3 Select
Encryption Protocol
from the pulldown menu.
Step 4 Select
Authentication Protocol
from the pulldown menu.
Step 5 Select
Key Management
from the pulldown menu.
This is the only parameter that does not have to be identical to the peer/
remote VPN device