Filter
Top Products
143
Appendix A CONFIG Commands
This enables this particular tunnel. Currently, one tunnel is supported.
Specifies the IP address of the destination gateway.
Specifies the IP address of the destination computer or internal network.
Specifies the subnet mask of the destination computer or internal network. The
subnet mask specifies which bits of the 32-bit IP address respresents network
information. The default subnet mask for most networks is 255.255.255.0 (class C
subnet mask).
See
page 73 for details about SafeHarbour IPsec tunnel capability.
See
page 73 for details about SafeHarbour IPsec tunnel capability.
See
page 73 for details about SafeHarbour IPsec tunnel capability.
See
page 73 for details about SafeHarbour IPsec tunnel capability.
Example: 0x1234)
See
page 73 for details about SafeHarbour IPsec tunnel capability.
Note: Aggressive Mode is a little faster, but it does not provide identity protection
for negotiations nodes.
BOTH set security ipsec tunnels name "123" tun-enable
(on) {on | off}
BOTH set security ipsec tunnels name "123" dest-ext-address
ip-address
BOTH set security ipsec tunnels name "123" dest-int-network
ip-address
BOTH set security ipsec tunnels name "123" dest-int-netmask
netmask
BOTH set security ipsec tunnels name "123" encrypt-protocol
(ESP) { ESP | none }
BOTH set security ipsec tunnels name "123" auth-protocol
(ESP) {AH | ESP | none}
BOTH set security ipsec tunnels name "123" IKE-mode
pre-shared-key-type (hex) {ascii | hex}
BOTH set security ipsec tunnels name "123" IKE-mode
pre-shared-key ("") {hex string}
BOTH set security ipsec tunnels name "123" IKE-mode
neg-method (main) {main | aggressive}