Filter
Top Products
121
Appendix A CONFIG Commands
CONFIG Commands
This section describes the keywords and arguments for the various CONFIG com-
mands.
ATM Settings
You can use the CLI to set up each ATM virtual circuit.
Enables the WAN interface of 3220-H to be configured using the Asynchronous
Transfer Mode (ATM) protocol.
Selects the virtual circuit for which further parameters are set. Up to eight VCCs
are supported; the maximum number is dependent on your Cayman Operating
System tier and the capabilities that your Service Provider offers.
Select the virtual path identifier (vpi) for VCC n.
Your Service Provider will indicate the required vpi number.
Select the virtual channel identifier (vci) for VCC n.
Your Service Provider will indicate the required vci number.
Select the encapsulation mode for VCC n. The options are:
Your Service Provider will indicate the required encapsulation mode.
DSL set atm option {on | off }
DSL set atm [vccn] option {on | off }
DSL set atm [vccn] vpi { 0 ... 255 }
DSL set atm [vccn] vci { 0 ... 65535 }
DSL set atm [vccn] encap
{ ppp-vc | ppp-llc | ether-vcmux | ether-llc |
ip-vcmux | ip-llc | ppoe-vcmux | pppoe-llc }
ppp-vc PPP over ATM, VC-muxed
ppp-llc PPP over ATM, LLC-SNAP
ether-vcmux RFC-1483, bridged Ethernet, VC-muxed
ether-llc RFC-1483, bridged Ethernet, LLC-SNAP
ip-vcmux RFC-1483, routed IP, VC-muxed
ip-llc RFC-1483, routed IP, LLC-SNAP
pppoe-vcmux PPP over Ethernet, VC-muxed
pppoe-llc PPP over Ethernet, LLC-SNAP