Filter
Top Products
40
ENGLISH
After you complete this portion of the setup, move
the cursor to “RETURN” with , , and cursor
buttons and press OK/ENTER button to go to the
2. SPKR SETUP menu.
Notes:
• Each time the subwoofer level is changed,
perform the bass peak level setup and correct the
setting.
• The bass peak level is not available in Pure Direct
and Source Direct mode.
• The selected value is displayed in the volume
column before the test signal starts.
2-4 BASS PEAK LEVEL
1.
Select “2. SPEAKER SETUP” from the MAIN
MENU.
2.
Select “BASS PEAK LEVEL” with the or
cursor buttons.
3.
Press the OK/ENTER button to enter the
selection.
With Dolby Digital and DTS, not only the LFE (Low
Frequency Effects), but also the bass of all
channels can be heard from the subwoofer or large
speakers. This procedure prevents these speakers
from becoming too loud and creating an
unbalanced sound. Since the sound is output at a
loud volume, perform this operation carefully.
Note:
• If your system does not include a subwoofer, this
setting will set the bass peak level for your front
speakers.
TEST SIGNAL: Press the or button.
“START” is displayed and a bass
test tone is generated from the
speaker which was designated for
bass signal output during setup.
There will be no audible sound
yet because the master volume
is set to minimum automatically.
VOLUME LEVEL
: Adjust the bass test tone output
level up until the bass begins to
distort or you reach the maximum
level with the
or cursor
button.
ENTER: Press the OK button, “ENTER”
will blink and the bass peak test
tone will no longer be generated.
The bass peak limit level for your
system has now been memorized.
BASS PEAK LEVEL
BASS PEAK TEST :START
VOLU
M
E LEVEL:+18.0dB
ENTER
RETURN EXIT
05.4.27, 5:42 PMPage 40