18
ENGLISH
CALIBRATE
Calibrate the LCD touch screen if the position you
touch on the screen does not match the intended
display position.
1.
Tap the Calibrate.
A message screen appears that “Touch the
top left corner”.
Calibrate
Touch the
top left corner
Cancel
Tap the + point.
2.
A message screen appear that “Touch the
button right corner”.
Touch the
bottom right
corner
Cancel
Tap the + point.
Adjust the Time
1.
Tap “+” or “–” once to adjust the time 1 minute
up or down.
2.
Press and hold “+” or “–” to adjust the time
more rapidly. The time will increase or
decrease in 30 minute increments.
The RC3200B will immediately reflect the time
change at the top of the screen.
THIRD SETUP PAGE
RC3200B Information
Calibrate
This page contains information that may be
important to the dealer in case of a defect.
The following information is displayed on this
screen:
• Free memory (in percentage), which gives you
an indication on how much memory is left to
(further) customize the RC3200B.
• Boot version
• Application version
• Configuration file
3.
Calibration is successful.
Calibrate
Calibration
succeeded
REVERT
Warning:
• When you revert the RC3200B, all customization
is lost permanently. You lose all RC3200B
settings, learned codes and recorded macros.
By tapping the Revert, the RC3200B will be
returned to the default configuration. Reverting to
the original configuration restores the RC3200B to
its initial state. You might have to revert when you
notice that scrolling through pages is slowing
down. This may occur if you have added a lot of
commands to the RC3200B.
1.
Tap the Revert.
A message screen appears, asking you to
confirm or cancel the revert process.
2.
Press OK or Cancel.
TO EXIT SETUP MODE
1.
Press the Mode button.
The Mode screen appears.
2.
Tap the Mode you want to go to. The RC3200B
switches to this mode. See also “WORKING
WITH MODE”. (See page 17)
05.4.27, 5:37 PMPage 18