Marantz SR9600 Home Theater System User Manual


 
16
ENGLISH
MULTIROOM A STATUS
To go to the Multiroom status screen, press Multi
button.
This status screen shows multiroom condition,
volume level, sleep timer, video input ,and audio
input in the multiroom location.
To exit from the status screen, press the RTN
button.
Note:
This feature works only with Multiroom A.
7.
Tap the soft button you want to select as a
macro.
A message screen appears.
8.
Tap Start.
The Home screen appears with the
RECORDING label at the top of the screen.
The buttons you tap on this screen will not be
recorded. From the Home screen you can go to
the different devices or you can press the Extra
button to go to the EXTRA screen to set delays
and beeps.
9.
Tap the soft button of the device you want to
go to.
The device screen appears.
10.
Tap the soft or hard buttons of the commands
you want to record.
11.
Press the page up and page down buttons to
go to different screens of the same device or
press the Home button to go to the Home
screen again.
12.
To add delays and beeps to the macro, press
the Extra button on the Home screen.
The EXTRA screen appears.
1)
To add a delay, tap one of the delay buttons.
By tapping several delay buttons, the
duration of the delay will be increased.
2) To add a beep, tap the beep.
3) Press the Home button to go to the Home
screen again.
13.
Press Stop button to stop recording.
A message screen appears.
14.
Press OK button to save the macro and return
to the Mode screen.The existing command of
the selected button is replaced by the macro.
To return to the Mode screen without saving
the macro, press Cancel button.
The button retains its previous command.
15.
Set the RC3200B to the Use mode to test the
recorded macro.
SHOW THE SR9600 STATUS ON THE
RC3200B
The RC3200B communication with the SR9600 is
capable of two-way, It can display the status of the
SR9600.
1/2 STATUS
To go to the first page of status screen, press the S
button.
This status screen shows the power condition,
volume level, sleep timer, video input ,and audio
input in the main room.
2/2 STATUS
To go to the second page of status screen, press
page up button.
This status screen shows the surround mode,
format and channel status of the input signal, in the
main room.
05.4.27, 5:37 PMPage 16