Filter
Top Products
Troubleshooting CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems
Error messages 90
Message: /etc/system has been updated since the
last reboot. CMS cannot run without an up-
to-date /etc/system file.
Explanation: /etc/system can change when a particular Solaris patch is
applied to the system or when state database replicas are
removed and re-added during a boot disk replacement.
Response: Reboot the system.
Message:
Failed activating new replicas, replicas
already active, or a second disk does not
exist
Explanation: The system does not have all the replicas it needs to be
functional (it needs at least three), or the replicas you
attempted to create already exist.
Response: Use
metadb -i
to verify that at least three replicas are
active. If not, add replicas (see Chapter 3).
Message:
Failed: disk c
x
t
y
d0 or c
x
’t
y
’d0 already
setup, exiting ...
Explanation: You are trying to set up a disk that is already a part of the
configuration. You probably mistyped the name.
Response: Set up the disk with the appropriate device name.
Message:
Illegal Request, cannot setup
Response: Check your hardware configuration and your usage of the
olds
command.
Message:
in order to attach disk, /cms must already
be mounted, exiting...
Response: Mount cms with this command:
mount /cms
Message:
ksh:
command
: not found
Explanation: Command does not exist or is not in the execution path.
Response: Use the entire path—as
pathname
/
command
—or add it
to the execution path with the following command:
# export PATH=$PATH:
pathname
The path of the
metastat, metadb, metattach
, and
metadetach
commands
is
/usr/opt/SUNWmd/sbin;
the
path of the olds command is
/olds
Error Messages (Continued)