Filter
Top Products
97
Using the Remote Controller with Other Components
—Continued
Deleting Remote Controller Modes
You can delete remote controller modes that you don’t
need, such as modes for components that you don’t have.
The AMP mode cannot be deleted.
Assigning Remote Controller Modes
With this function you can assign a remote controller
mode to an input source. This is useful when you con-
nect, say, a CD recorder to the TAPE IN/OUT sockets.
By assigning the CDR remote controller mode to the
TAPE input source, you can use the remote controller to
control the CD recorder.
1
Press and hold the [Custom] but-
ton for more than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“MODE,” and then press the
scroll wheel.
3
Roll the scroll wheel to select
“DEL,” and then press the scroll
wheel.
4
Roll the scroll wheel to select the
mode you want to delete, and
then press the scroll wheel.
If the mode is deleted successfully,
after “OK” has been displayed, the
DEL display (step 3) reappears.
1
Press and hold the [Custom] but-
ton for more than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“MODE,” and then press the
scroll wheel.
3
Roll the scroll wheel to select
“ASSIGN,” and then press the
scroll wheel.
4
Roll the scroll wheel to select an
input source, and then press the
scroll wheel.
5
Roll the scroll wheel to select the
mode you want to assign to the
specified input source, and then
press the scroll wheel.
If the assignment is successful, after
“OK” has been displayed, the ASSIGN
display (step 3) reappears.