Filter
Top Products
82
Net-Tune
—Continued
2
This section explains how to manually configure the
DTR-8.4’s network settings.
If your router’s DHCP server is enabled, by default the
DTR-8.4 is set use DHCP to configure itself automati-
cally (i.e., the DHCP/AUTO IP setting is On), so you
don’t need to change any of the settings on the
“5. Network Setup” menu. If your router’s DHCP server
is disabled, for example, you’re using static IP addresses,
you’ll need to configure these settings yourself. A
knowledge of Ethernet networking is essential.
What’s DHCP/AutoIP?
DHCP (Dynamic Host Configuration Protocol) and Auto
IP (Automatic IP Addressing) are services used by rout-
ers, computers, the DTR-8.4, and other devices to auto-
matically configure themselves on the network.
What’s DNS?
The DNS (Domain Name System) translates domain
names into IP addresses. For example, when you enter a
domain name such as
www.integrahometheater.com
in
your Web browser, before accessing the site, your
browser uses DNS to translate this into an IP address, in
this case 63.148.251.142.
Network Settings
1
Press the [Input] button, and then
roll the scroll wheel to select
either “IRD” or “MSRV.”
2
Press the scroll wheel, and then
press the [Setup] button.
If the Basic menu appears, use the
Down [ ] button to select Advanced
Menu, and press the [Enter] button to
display the Advanced menu.
1, 2
2, 7
3–6
3, 4, 6
1
3
Use the Up/Down [ ]/[ ] but-
tons to select “5. Network Setup,”
and then press the [Enter] but-
ton.
The Network Setup menu appears.
4
Use the Up/Down [ ]/[ ] but-
tons to select the menu items,
and then press the [Enter] but-
ton.
The IP Address menu is shown here.
5
Use the Up/Down [ ]/[ ] but-
tons to select the settings, and
use the Left/Right [ ]/[ ] but-
tons to set them.
To enter an IP address, select the set-
ting, and then press the [Enter] button.
The [ ]/[ ]/[ ]/[ ] buttons can
then be used to enter numbers. Press the
[Enter] button again to set the number.
The settings are explained below.
6
When you’ve completed the set-
tings on any menu, press the
[Return] button to return to the
“5. Network Setup” menu, use
the Up/Down [ ]/[ ] buttons to
select “Save Settings,” and then
press [Enter].
Don’t turn off the DTR-8.4 while the
settings are being saved (about 2 sec-
onds), otherwise they’ll be lost.
7
Press the [Setup] button.
The setup menu closes.
5.Network Setup
1.IP Address
3.MAC Address
4.Client Setup
2.Proxy Setup
[ENTER]Quit:[SETUP]
Save Settings
→