Filter
Top Products
49
Basic Setup
—Continued
Changing the Remote Controller’s Control ID
This section explains how to change the remote control-
ler’s ID. You may need to change this if the DTR-8.4’s
remote controller interferes with other Integra/Onkyo
components located in the same room.
Note:
If you change the remote controller’s ID, be sure to select
the same ID on the DTR-8.4 (page 48). The default ID
for both the DTR-8.4 and remote controller is 1.
This section explains how to specify the TV system used
in your area. (This setting is not available on the Ameri-
can model.)
1
Hold down the remote control-
ler’s [Custom] button for more
than three seconds.
The remote controller enters Custom
mode.
2
Roll the scroll wheel to select
“SETUP” menu, and then press
the scroll wheel.
3
Roll the scroll wheel to select ID
menu, and then press the scroll
wheel.
4
Roll the scroll wheel to select an
ID—1 (default), 2, or 3—and then
press the scroll wheel.
Select the same ID as that set on the
DTR-8.4.
Specifying the TV System
(Australian model only)
1
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
2
Use the Up/Down [ ]/[ ] but-
tons to select “0. Hardware
Setup,” and then press the
[Enter] button.
The Hardware Setup menu appears.
3
Use the Up/Down [ ]/[ ] but-
tons to select “4. TV Format,” and
then press the [Enter] button.
The TV Format menu appears.
4
Use the Left/Right [ ]/[ ] but-
tons to select:
Auto:
The DTR-8.4 automatically
detects the TV system.
PAL:
Select if the TV system in
your area is PAL.
NTSC:
Select if the TV system in
your area is NTSC.
0-4.TV Format
a.TV Format
:Auto
Quit:[SETUP]