Filter
Top Products
53
Basic Operation
—Continued
Setting the Input Signal Format
With this function you can set the signal format (analog,
digital, or multichannel) that you want to use with AV
components that are connected to a digital input, analog
input, and the multichannel input. This can be set indi-
vidually for each input source.
Note:
• This procedure can also be performed by using the
DTR-8.4’s input selector buttons and [Audio Selector]
button.
Fixing the Digital Input Format
With this function you can set the digital inputs to accept
only DTS, PCM, or both formats. This can be set indi-
vidually for each input source.
Notes:
• Select All or DTS when playing a CD or LD with
DTS. If you select PCM, only noise will be heard.
• This procedure can also be performed by using the
DTR-8.4’s input selector buttons, [Setup] button,
[ ]/[ ]/[ ]/[ ] buttons, and [Enter] button.
1
Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to set.
2
Press the scroll wheel, and then
press the [Audio SEL] button
repeatedly to select “Auto,” “Mul-
tich,” or “Analog.”
Auto:
The assigned digital input
has priority over the analog
input. If no digital signal is
present, the analog input is
used.
Multich:
The multichannel input is
used.
Analog:
The analog input is used
even if the input source is
connected digitally.
1
Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to set.
2
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
3
Use the Up/Down [ ]/[ ] but-
tons to select “2. Input Setup,”
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4
Use the Up/Down [ ]/[ ] but-
tons to select “1. Digital Setup,”
and then press the [Enter] but-
ton.
The Digital Setup menu appears.
5
Use the Up/Down [ ]/[ ] but-
tons to select “b. Digital Format,”
use the Left/Right [ ]/[ ] but-
tons to select a format, and then
press the [Setup] button.
All:
PCM, Dolby Digital, and
DTS formats are accepted. If
no digital signal is present,
the analog input is used.
DTS:
Select this option if playing a
DTS CD with the All option
produces noise while the
DTR-8.4 is identifying the
DTS format or when using
fast forward or fast reverse. If
the input signal is anything
other than DTS, nothing is
output.
PCM:
Select this option if playing a
CD or other PCM source with
the All option causes the tops
of tracks to be clipped. If the
input signal is anything other
than PCM, nothing is output.
2-1.Digital Setup
a.Digital Input
:COAX1
b.Digital Format
:All
Quit:[SETUP]
Input:DVD