Filter
Top Products
20
Remote Controller
—Continued
Tape mode is used to control an Integra/Onkyo cassette
recorder connected to the DTR-8.4 via .
To select
Tape mode, press the scroll wheel. “AMP” appears
on the display
.
Note:
While neither the [Input] button nor [Mode] button is
illuminated, the scroll wheel changes the input source
and remote controller mode simultaneously (e.g., set the
input source and mode to “TAPE.”)
A
Mode button
This button is used with the scroll wheel to select
the remote controller modes. Press the scroll wheel
until “AMP” appears on the display.
B
Previous/Next [ ]/[ ] buttons
The Previous [ ] button is used to select the pre-
vious track. During playback it selects the begin-
ning of the current track. The Next [ ] button is
used to select the next track.
The Previous/Next [ ]/[ ] buttons make not
work properly with some cassette tapes depending
on how they were recorded.
C
Rewind/FF [ ]/[ ] buttons
The Rewind [ ] button is used to start rewind. The
FF [ ] button is used to start fast forward.
D
Rec [ ] button
This button is used to start tape recording.
E
Light button
This button is used to turn on or off the remote con-
troller’s illuminated buttons.
F
Input button
This button is used to select the input source. Press
this button first, and then roll the scroll wheel until
“TAPE” appears on the display.
G
VOL button
This button is used to set the volume of the
DTR-8.4.
H
Muting button
This button is used to mute the DTR-8.4. This func-
tion can be set only with the remote controller.
I
Play [ ] button
This button is used to start tape playback.
J
Stop [ ] button
This button is used to stop tape playback.
K
Reverse Play [ ] button
This button is used to start reverse playback.
Tape Mode
A
E
G
8
F
2
3
4
J
K
9
Scroll wheel