Filter
Top Products
68
Advanced Setup
—Continued
■
f. D.F. Mono
With this setting you can specify the listening mode to be
used when a mono digital audio signal is played (DVD,
etc).
Only listening modes that can be used with mono PCM,
Dolby Digital, or DTS can be selected.
• The Last Valid option means that the listening mode
selected last will be used.
Notes:
• The b, c, d, e, and f settings are available only when an
digital audio input is assigned to the selected input
source.
•You can select other listening modes during playback
(see page 59), however, the listening mode assigned
here will be resumed after the DTR-8.4 has been set to
Standby.
Assigning the A & B 12V Trigger Outputs
This section explains how to assign input sources to the
12V TRIGGER OUT A and B outputs.
This section explains the audio and listening mode set-
tings you can use to tailor the sound as you like.
1
Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to assign.
2
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
3
Use the Up/Down [ ]/[ ] but-
tons to select “2. Input Setup,”
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4
Use the Up/Down [ ]/[ ] but-
tons to select 7. 12V Trigger
Setup, and then press the [Enter]
button.
The 12V Trigger Setup menu appears.
5
Use the Up/Down [ ]/[ ] but-
tons to select a. Trigger A or b.
Trigger B, and use the Left/Right
[ ]/[ ] buttons to select:
On:
Trigger output active while
input source selected.
Off:
Trigger output not active
while input source selected.
6
Press the [Setup] button.
The setup menu closes.
Audio Adjust Functions
1
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
2
Use the Up/Down [ ]/[ ] but-
tons to select “3. Audio Adjust,”
and then press the [Enter] but-
ton.
The Audio Adjust menu appears.
Advanced Menu
2.Input Setup
2-7.12V Trigger Setup
a.Trigger A :On
b.Trigger B :Off
Quit:|SETUP|
Input:DVD
Input:DVD