Filter
Top Products
63
Advanced Operation
This section explains how to use the multichannel analog
input. Connecting the 5.1 or 7.1 analog outputs of your
DVD player to the multichannel analog input allows you
to enjoy DVD-Audio discs and Super Audio CDs, pro-
viding that your DVD player supports those formats. See
page 29 for connection details.
Setting the Multichannel Input
Before using the multichannel input, you need to assign
it to an input source. By default, it’s assigned to the DVD
input source, as shown in the following table, so if you
connect a DVD player to the multichannel input, no fur-
ther settings are required.
Note:
• The Net-Tune input source cannot be set to Yes.
Note:
• This procedure can also be performed by using the
DTR-8.4’s [Setup] button, [ ]/[ ]/[ ]/[ ] but-
tons, and [Enter] button.
Using the Multichannel Input
Input source Default setting
DVD Yes
VIDEO 1 No
VIDEO 2 No
VIDEO 3 No
VIDEO 4 No
VIDEO 5 No
CD No
PHONO No
TUNER No
TAPE No
1
Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to set.
2
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears.
3
Use the Up/Down [ ]/[ ] but-
tons to select “2. Input Setup,”
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4
Use the Up/Down [ ]/[ ] but-
tons to select “2. Multichannel
Setup,” and then press the
[Enter] button.
The Multichannel Setup menu appears.
5
Use the Left/Right [ ]/[ ] but-
tons to select:
Yes:
Assigned to multichannel
analog input.
No:
Not assigned to multichannel
analog input.
6
Press the [Setup] button.
The setup menu closes.
Advanced Menu
2.Input Setup
2-2.Multichannel Setup
a.Multichannel :Yes
Quit:|SETUP|
Input:DVD
Input:DVD