Filter
Top Products
2.3 Verifying Configuration Data, Continued
Procedure, continued
Table 3 Verifying Transmitter’s Configuration Data, Continued
Step Press Key Read Display or Action Description
3
B
CONF
NON-VOL
ENTER
(Yes)
CLR
(No)
NEXT
H
NON-VOL
ENTER
(Yes)
ENTER
(YES)
NON-VOL
CLR
(No)
NGO
ITYORM
IST C F
CONF ?
ITYORMCONF
LINEAR
NGO
ITYORM
IST C F
CONF ?
CONF I G
CMe ntr o ?ef
ST
i
g
SCFO
W
RK NI.G..
CMe ntr oef
ig
Pers
en
Met re
CMe ntr oef
ig
Bd
t
Cnouf
ig
Met re
CMe ntr oef
ig
re ?
"2H9O
_
3
EMe gtr neU
ni
F
ts
CONF I G
CMe ntr o ?ef
ST
i
g
Access configuration menu.
Present output conformity is linear
Exit menu selection.
Call up next menu selection.
Enters meter configuration function
and confirms that local smart meter
is present. Timed prompt - See next
display.
ATTENTION
If prompt “No Meter
Present” appears, prompt times out
in a few seconds, as described
above, and calls up the “Configure
Meter?” prompt. This means that
you can access the meter
configuration function without the
local smart meter installed. If prompt
“Mtr not Supportd” appears, prompt
times out and returns to previous ST
CONFIG prompt. This means that
you are working with a pre-release
300 transmitter that does not
support the local smart meter option
and, therefore, can not access the
meter configuration function.
Prompt asks if you want to configure
smart meter.
Calls up present meter Engineering
Unit selection.
Exit menu selection.
4
D
UNITS
1UN I TS
"
H2O
_
39F
PT 1ØØ1S
SFC will display range values in
inches of water @ 39º F (4º C).
Continued on next page
2/05 ST 3000 Release 300 Installation Guide
11