Filter
Top Products
1.2 Preliminary Checks, Continued
Series and model
number data,
continued
For a complete breakdown of the table selections in your model number,
please refer to the appropriate Specification and Model Selection Guide
that is provided as a separate document.
ATTENTION
Previous models of the ST 3000 transmitter with designations of Series
100, Series 100e, Series 600, and Series 900 have been supplied at various
times since the ST 3000 was introduced in 1983. While all these
transmitters are functionally alike, there are differences in housing and
electronics design. This Installation Guide only applies for Release 300,
Series 100 transmitters with software version 3.0 or greater and Release
300, Series 900 transmitters with software version b.0 or greater.
Release 300 transmitters can be identified by the “R300” designation on
the nameplate.
Earlier Release
ST3000 Transmitters
If you have a Series 100e or a Series 900 non-release 300 transmitter, you
must refer to the ST 3000 Smart Transmitter Installation Guide
34-ST-33-31 instead.
Communicating with
the ST3000
Transmitter
Communication with your ST 3000 Smart Transmitter can be
accomplished by using any of the following interfaces:
• Honeywell’s hand-held Smart Field Communicator (SFC).
• Smartline Configuration Toolkit (SCT 3000) that runs on a variety of
Personal Computer (PC) platforms.
• Global Universal Station (GUS), if the transmitter is digital integrated
with Honeywell’s TPS system.
Continued on next page
2/05 ST 3000 Release 300 Installation Guide
3