Filter
Top Products
Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications
1
Turn off the power using <POWER>.
2
Press <POWER> while simultaneously pressing
<STANDARD> and <HOME THX CINEMA>.
3
Once the display starts ashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
All settings are reset when the microcomputer is reset.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Playback