Denon AV SURROUND PRE-AMPLIFIER Stereo Amplifier User Manual


 

Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications
Record Player
• When connecting a record player with an MC cartridge, use a
commercially available MC head amplifier or a step-up transformer.
• Induction humming (a booming sound) may be produced from the
speakers if the volume is raised with no record player connected.
• With some record players, noise may be generated when the ground
wire is connected. If so, disconnect the ground wire.
(/%
"6%*0
065
R
L
Turntable (MM cartridge)
NOTE
The AVP-A1HDCI’s SIGNAL GND terminal is meant to reduce noise
when a record player is connected. This is not a safety ground
terminal.
R
L
R
L
"6%*0
"6%*0
$0"9*"-
065
3-3-
065
9-3
065
CD Player
Connect the cables to be used.
CD player
iPod
®
Example :
R
L
R
L
"4%3
iPod
• When using an optical cable or a BNC cable for the digital audio
connection, make the settings at GUI menu “Source Select” – “CD”
– “Assign” – “Digital” (vpage 48).
• The default analog audio input setting is “RCA”. When using a
balanced cable for the analog audio connection, make the settings at
GUI menu “Source Select” – “CD” – “Assign” – “Analog” (vpage
49).
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• To assign the iPod to a connector other than VCR (iPod), make the
settings at GUI menu “Source Select” – “(input source to which
iPod dock assigned)” – “Assign” – “iPod dock” (vpage 49).
Use a DENON Control Dock for iPod (ASD-1R, sold separately) to
connect the iPod to the AVP-A1HDCI. For instructions on the Control
Dock for iPod settings, refer to the Control Dock for iPod’s operating
instructions.
NOTE
The default AVP-A1HDCI balance model XLR input connectors pin
alignment is as shown.
q : GROUND
w : HOT
e : COLD
Connections