Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting Specifications
s XLR Out Polarity
Set to switch the XLR pre-out terminal polarity.
d POA Setting
Set when connecting the receiver to a POA-A1HDCI.
POA LINK
Set when connecting the receiver to a POA-A1HDCI through a
CONTROL LINK.
[Selectable items]
OFF
ON (Single)
ON (Dual)
[Selectable channels]
Front L
Front R
Center
Surround A L
Surround A R
Surround B L
Surround B R
Surround Back L
Surround Back R
Subwoofer 1
Subwoofer 2
Subwoofer 3
[Selectable items]
XLR
qGROUND
wHOT
eCOLD
XLR (INV)
qGROUND
wCOLD
eHOT
g
Source Delete
Remove input sources that are not used from the display.
[Selectable items]
ON
Delete
NOTE
• Input sources being used in the various zones cannot be deleted.
• Input sources set to “Delete” cannot be selected from GUI menu
“Source Select” or using the SOURCE SELECT knob on the main unit
or SOURCE SELECT button on the remote control unit.
h GUI
Make GUI related settings.
Screensaver
Make screensaver settings.
Use the screensaver to prevent burn-in on the monitor screen.
When set to “ON”, the screensaver is activated if there is no activity
for about 3 minutes.
[Selectable items]
ON
OFF
Wall Paper
Change the GUI background.
[Selectable items]
Picture
Black
Gray
Blue
Format
Select the video output signal format to match the monitor.
[Selectable items]
NTSC
PAL
NOTE
When a format other than the video format of the connected monitor
is set, the picture will not be displayed properly. Use the procedure
described below to change the video format.
f Volume Control
Set the MAIN ZONE volume setting.
Volume Limit
Make a setting for maximum volume.
[Selectable items]
OFF
–20dB
–10dB
0dB
Power On Level
This sets the volume set when the MAIN ZONE’s power is turned
on.
[Selectable items]
Last
– – –dB
–80dB ~ 18dB
Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the MAIN ZONE.
[Selectable items]
Full
–40dB
–20dB
POA 1/POA 2
Set POA-A1HDCI for which the MODE select switch is set to “1” or
“2”.
LINK Check
Check CONTROL LINK.
n Input Selector
Select the setup channel.
[Selectable items]
L1
R1
L2
R2
L3
R3
L4
R4
L5
R5
Select the connector input to be used for each channel.
[Selectable items]
RCA
XLR
OFF
n Power Amp
Select the setup channel.
[Selectable items]
L1/L2
L3/L4
L5/R5
R1/R2
R3/R4
Set the power amp usage for each channel.
[Selectable items]
NORMAL
BI-AMP
BRIDGE (BTL)
See the POA-A1HDCI operating instructions.
Setup