Filter
Top Products
35
ENGLISH
[2] Delay time (distance setting)
• Input the distances from the listening position and the various speakers to set the surround delay time.
• Upon shipment from the factory default the delay time is set to the default values in step 3 below.
Preparation:
Measure the distance from the listening position to the various speakers.
FRFL
SRSL
Center
L1: Distance between center speaker
and listening position
L2: Distance between front speakers
and listening position
L
3: Distance between surround
speakers and listening position
Listening position
1
2
If you are not at the system setting changing menu screen,
read step 1 and 2 on page 33.
At the system setting changing menu screen, use the
0
and
1 cursor buttons to select “DELAY TIME”, then press the
ENTER button.
• The delay time setting screen appears.
ENTER
Remote control unit Remote control unit
3
At “Default”, select “Yes ” to set the delay times for the
different speakers to the default values.
• The unit for the distance can be switched between “m”
(meters) and “ft” (feet) using the
0
and
1 cursor buttons.
If you do not want to change the unit, press the ª cursor
button to proceed to the next step.
B Yes: The values are set to the defaults.
B No: The current settings are retained.
4
Use the
•
and ª cursor buttons to select the speaker, then
use the
0
and
1 cursor buttons to set the distance between
the speaker and the listening position.
• The distance changes by 0.1 meters (or 1 foot when the
unit is set to feet) each time the
0
and
1 cursor button is
pressed. Select the value closest to the measured
distance.
5
Press the ENTER button to enter the
settings.
• The next screen in the system setting
changing menu appears.
ENTER
Make sure the difference in the distances set for the
various speakers is no greater than 3.0 meters (10 feet).
If an inappropriate distance is set, “CAUTION: OUT OF
SETTING RANGE” is displayed. Change the position of the
speaker and make the setting over.
Remote control unit