Filter
Top Products
11
ENGLISH
(4) Connecting a TV
• Use the commercially 21-pin SCART cable to connect the TV’s 21-pin SCART terminal to the ADV-M71’s 21-pin SCART terminal (AV1).
Monitor TV
• Connect this unit video outputs to the TV either directly. Do
not connect it via a VCR (video cassette recorder). Some
discs contain copy prohibit signals. If such discs are played
via a VCR, the copy prohibit system may cause disturbance
in the picture.
• Set the “TV TYPE” in “VIDEO SETUP” in “DVD SETUP” to
comply with your TV’s video format. When the TV is PAL
formated, set to PAL. (See page 29.)
•
The factory default is “PAL”. When in the stop mode with the
function set to “DVD”, the setting can also be switched with the
“NTSC/PAL” button on the remote control unit. If the setting
does not match your TV’s video format, switch it from the
remote control unit, then set “TV TYPE” under “VIDEO SETUP”
at “DVD SETUP” to the setting match your TV’s video format.
NOTES:
• The audio and video signals for the function selected on the set are output.
Audio output signals
• The tuner and DVD audio playback signals and the audio signals input to the AUDIO INPUT jacks are output.
• When Dolby Digital and DTS DVD are played, the audio signals are converted to 2-channel signals before being output.
• The audio output level is fixed. If you do not wish to play the sound on the connected TV, turn the TV’s volume down to the minimum.
Video output signals (Function “DVD” only)
• The DVD video playback signals is output.
• The selection of the VIDEO, S-VIDEO and RGB video signals is set at “AV1 VIDEO OUTPUT” system setup item. (By default all are set to
“VIDEO”. See page 29.)