Filter
Top Products
Manual Actuator
Assembly Removal
Step 1
Step 2
Step 3
72
Operation
Figure 6
After you have successfully acquired the satellite and all adjustments have been made,
the manual actuator should be removed. The following steps provide the procedure for
the proper removal of the manual actuator assembly.
Remove the manual actuator assembly by first removing the hardware securing the
actuator to the base angle. Note: The adjustment kit assembly should be removed after
the antenna has been adjusted. Store the manual actuator assembly and the corre-
sponding hardware in a dry area for future use.
Remove the remaining clamp segments with the corresponding hardware.
After the antenna is pointed at the satellite, tighten all azimuth and elevation setscrews
to 35 foot-pounds.
Figure 5